Feb 15, 2014
Sean Stephens
wrote
Well, my pump (HY3000S) never really started that great, but it would always run after a little push and it has been going well for a few years. Recently, it locked up and will no longer start. I pulled it out and the impeller is swollen in a couple of spots. Feeling inside the pump it is a little rough inside, probably from the pump swelling and running for quite a while. Should I just replace the impeller or is a new pump needed? If I need to buy a new pump, would I be well off to upgrade to a different model? The number on the back of the pump is 0006498 and I have noticed there is a variety of replacement impellers.
Thanks
Thanks
Reply
1 Answer
Feb 17, 2014
Carlos
agent
wrote
When did you purchase the pump? How old is it?
Most likely, all you need is a new impeller. You can purchase the impeller directly from our site. Here is the link:
http://www.coralvue.com/bubble-blaster-pump-pinwheel-impeller
Just make sure you select the Bubble Blaster 3000 impeller.
Regards,
Carlos
CoralVue
Most likely, all you need is a new impeller. You can purchase the impeller directly from our site. Here is the link:
http://www.coralvue.com/bubble-blaster-pump-pinwheel-impeller
Just make sure you select the Bubble Blaster 3000 impeller.
Regards,
Carlos
CoralVue