Jul 10, 2022
Bob Nordgren
wrote
OP_2kDC
started functioning properly right out of the box - but in a bucket test it clearly needed calibration -
Performed exchange connection - and all seemed to to work - tested with 2 liters and was off by 235ml - and corrected
However when I attempted to exchange in discharge/Add saltwater mode - only the first prompt responds and then adds only very slowly
did a factory reset and both pumps worked to prime, but then when I re-did exchange connection, the same thing happened - only one of the discharge/add salt water propmts would respond
so not sure what to do next
started functioning properly right out of the box - but in a bucket test it clearly needed calibration -
Performed exchange connection - and all seemed to to work - tested with 2 liters and was off by 235ml - and corrected
However when I attempted to exchange in discharge/Add saltwater mode - only the first prompt responds and then adds only very slowly
did a factory reset and both pumps worked to prime, but then when I re-did exchange connection, the same thing happened - only one of the discharge/add salt water propmts would respond
so not sure what to do next
Reply
2 Answers
Jul 11, 2022
Jeremy Rykiel
agent
wrote
Sorry for the issues you are having with your X2SR. Please submit a support ticket at support.coralvue.com so that our support staff can better assist you with your issue.
Jul 11, 2022
Bob Nordgren
wrote
thanks
will do
will do