May 02, 2016
Lee Chandler
wrote
Hi
Cleaned both my Gyres yesterday and since cleaning them they don't seem to be following the code on my Apex system. I haven't changed any setting at all. Simply cleaned and returned. I can turn them on and off via apex so I know its still seeing them both. Any ideas please? Its upsetting my Anemone so need to sort asap.
thanks
Cleaned both my Gyres yesterday and since cleaning them they don't seem to be following the code on my Apex system. I haven't changed any setting at all. Simply cleaned and returned. I can turn them on and off via apex so I know its still seeing them both. Any ideas please? Its upsetting my Anemone so need to sort asap.
thanks
Reply
6 Answers
May 02, 2016
Lee Chandler
wrote
Just seen you mention on another post this:
"The motor should run for about 10 seconds and then shut off as the controller detects the lack of water drag from the motor running without propellers."
Mine is running constant at full speed.??
"The motor should run for about 10 seconds and then shut off as the controller detects the lack of water drag from the motor running without propellers."
Mine is running constant at full speed.??
May 02, 2016
Carlos
agent
wrote
Where are you located?
May 02, 2016
Lee Chandler
wrote
Located in the UK
May 02, 2016
Carlos
agent
wrote
This is the website for the US distributor and we only support US customers. You will need to contact your local distributor for all gyre support. For a list of all distributors, please head over to www.maxspect.com.
May 02, 2016
Lee Chandler
wrote
Thanks Carlos. Any idea what the issue could be though?
Thanks
Thanks
May 02, 2016
Carlos
agent
wrote
I am sorry but you will need to contact your distributor for all support.