Jan 16, 2014
Kris O.
wrote
Is condensation normal on the external pump where the slits are? It's not leaking on the floor, but if i touch it then my hand is wet..... what gives?
Reply
2 Answers
Jan 16, 2014
Carlos
agent
wrote
Did you check to make sure that the o-rings were properly placed and create a tight seal?
Jan 16, 2014
Kris O.
wrote
No. I had the skimmer taken apart by the place i bought it from because there was a sea shell stuck in it. They put it back together and tested it too. It didn't leak then so im guessing they're in right. Im kind of hesitant to keep taking it apart and puttingit back ttogether again cause i have teflon tape on it and the rest of the connections are doing just fine.