power adapter to Icecap and two gyre 250

Oct 12, 2018

Salah wrote

Hi,
I have a question about if I can go with one power supply using split outputs to power the two Icecap modules I have.
The maxspect gyre advanced controller comes with one power supply that can power up two gyre XF250.
So based on above, if using a power adapter with same specs as the original power supply that comes with the advanced controller and using a DC one input to two outputs, would that work?

I already bought two different power supplies with same specs as the original power supply but was just checking in theory if it will work with one power supply
Power supply i bought
Input: 100-240 V ~ 50-60 Hz
Output: 24 V, 4 A Plug
dimensions: 5.5 x 2.5 mm
• Plug polarity: external - (minus); inside + (Plus)

Thanks in advanced.

4 Answers

Oct 12, 2018

Carlos agent wrote

Unfortunately that cannot be done. Each module will require its own power supply.

Oct 12, 2018

Salah wrote

Thanks for replying Carlos. What about having a power supply with higher output power
Output: 24 V, 6.25 A
That also would not be enough to power the two Icecap modules+Two gyres?

Oct 12, 2018

Carlos agent wrote

Unfortunately we have not tested that so we cannot tell you if it will work or not. If you do decide to go that way, it is a DIY project and it would not be covered under warranty if something happens to the modules due to using the wrong power supply.

Oct 12, 2018

Salah wrote

Understood. Thanks again. I was just wondering