Jul 06, 2017
Jack Rogers
wrote
I've programmed 20 time settings in my XF 250 controller. At 12:00 am (actual time), the controller jumps to the last setting (#20 in my case). In other words, if #15 runs from 23:30 - 01:30, at 00:00 actual time, the controller will jump to #20, which is programmed to start at 06:00. This appears to be a bug.
Also, 1) Is there a way to delete or turn-off a programmed time setting? In other words, if I created #21, could I delete it? 2) Is there a way to run just 1 pump on any particular setting if you have 2 pumps connected?
Also, 1) Is there a way to delete or turn-off a programmed time setting? In other words, if I created #21, could I delete it? 2) Is there a way to run just 1 pump on any particular setting if you have 2 pumps connected?
Reply
8 Answers
Jul 07, 2017
Carlos
agent
wrote
Where are you located?
Jul 07, 2017
Jack Rogers
wrote
Mississippi.
Jul 07, 2017
Carlos
agent
wrote
Have you updated the firmware version on the controller? You can do so here...
http://blog.coralvue.com/gyre-advanced-controller-firmware-updates/
http://blog.coralvue.com/gyre-advanced-controller-firmware-updates/
Jul 07, 2017
Jack Rogers
wrote
I did about a month ago. Any way to verify the running version number?
Jul 07, 2017
Carlos
agent
wrote
Yes, when you first power up the controller, it will display the firmware version as it initializes.
Jul 07, 2017
Jack Rogers
wrote
It is A 1.7.
Jul 07, 2017
Carlos
agent
wrote
Please submit a private ticket and be sure to include proof of purchase as well as your shipping info.
Jul 07, 2017
Jack Rogers
wrote
Will do, but I included the proof of purchase when I registered for warranty.