Jun 13, 2014
Joel Levine
wrote
Can I use ozone with my Octopus RO-PS-3000 INT and its Hy-3000s bubble blaster??
Joel
Joel
Reply
6 Answers
Jun 13, 2014
Jeremy Rykiel
agent
wrote
Yes the material that the skimmer is built with are considered ozone safe. You can simply splice into the airline right before the venturi to inject the ozone. Also be sure the top of the skimmer lid vents through activated carbon to filter ot the O3.
Jun 13, 2014
Joel Levine
wrote
Leave the current airline there - just splice into it?
Where and how do I place the carbon - below or above the lid? Vents through activated carbon - how?
Joel
Where and how do I place the carbon - below or above the lid? Vents through activated carbon - how?
Joel
Jun 13, 2014
Jeremy Rykiel
agent
wrote
Venting the lid is going to take some unique fabrication. I am working on a carbon venting lid for such uses as ozone but its still in its early stages. I usually just get several large bags of carbon and place them around the top of the lid.
Jun 13, 2014
Joel Levine
wrote
Should I drill a hole in the lid and put carbon bag on top of it.
Also where do I splice in the ozone tube specifically?
Joel
Also where do I splice in the ozone tube specifically?
Joel
Jun 13, 2014
Jeremy Rykiel
agent
wrote
Your lid already has multiple holes. you just need to cover them all so that the outgoing air is filtered before entering your atmosphere. The ozone is best injected as close to the venturi/air intake as possible.
Jul 16, 2014
System
wrote
Your ticket has been closed and marked as resolved due to inactivity. If this is not the case, just reply to this email to reopen the ticket.