Dec 19, 2016
Vergel C. Guintu
wrote
i have a max-etc gyre xf 130 and ice cap module but how do i connect this to this compactor
Reply
6 Answers
Dec 19, 2016
Carlos
agent
wrote
You are trying to connect two things that are not compatible. One is the power jack and it is connected to the power supply brick and the other is a 3.5mm earphone jack which is connected to the side of the module.
Dec 19, 2016
Vergel C. Guintu
wrote
thanks for the fast reply, I thought with the ice cap module I don't need the power brick that came with the gyre pump. the Y connector connect to the gyre pump. the other connector to the side of the ice cap module and this last connector to the power brick of the gyre pump?...
Dec 19, 2016
Carlos
agent
wrote
No, you still need to connect the gyre pump to the power supply. The IceCap module replaces the Gyre's native controller only.
Dec 19, 2016
Vergel C. Guintu
wrote
thanks just figure it out now. So the other end of the y connector is not used then..
Dec 19, 2016
Vergel C. Guintu
wrote
is there a single end cable for this gyre
Dec 19, 2016
Jeremy Rykiel
agent
wrote
Correct the other end of the y cable is not used unless you have another 0-10V controllable product. Each 0-10V port on the Apex is capable of controlling 2 products. If you use a single cable you forfeit two controls for one unless you favored using the alternating gyre mode. http://www.coralvue.com/alternate-gyre-mode-modified-cable-for-icecap-gyre-interface-module