Feb 20, 2020
Paul Sokol
wrote
I just installed the Classic 1000 -HOB. I am getting a lot of micro bubbles back into my tank. Only been running a couple hours. Is this normal for a new install or is there something wrong?
Reply
1 Answer
Feb 21, 2020
Angie Brumfield
agent
wrote
Right now you skimmer is breaking in. During this period you should not attempt to dial in or set the skimmer. I suggest running the skimmer with the cup set as high as possible for the first 3-4weeks running. You will likely experience abnormal air suction noise as well as inconsistent performance.
Right now your skimmer has oils from manufacturing and handling which will dissipate as the skimmer ages. Because oil inhibits foam production you will not see much foam produced from the air being injected. The hydrostatic surface tension of the water is lost. As the skimmer runs you will see a point where it looks like it kicked in and is working as you would expect.
Please be cautious if it is prior to the 3-4 week mark as the skimmer could still be breaking in and you can experience and overflow or create lots of microbubbles.
The pump itself will run smoother as the impeller lubricates and the bacteria forms on all wet surfaces which will provide you with stability.
Right now your skimmer has oils from manufacturing and handling which will dissipate as the skimmer ages. Because oil inhibits foam production you will not see much foam produced from the air being injected. The hydrostatic surface tension of the water is lost. As the skimmer runs you will see a point where it looks like it kicked in and is working as you would expect.
Please be cautious if it is prior to the 3-4 week mark as the skimmer could still be breaking in and you can experience and overflow or create lots of microbubbles.
The pump itself will run smoother as the impeller lubricates and the bacteria forms on all wet surfaces which will provide you with stability.